Table of Contents
Advertisement
Replacing the Batteries
Replace the batteries in the remote control as described below:
1. Turn the remote control over.
2. Push the tab on the battery cover
as you lift the cover off.
3. Install two AA alkaline batteries,
inserting the
and
+
shown.
4. Position the cover as shown, then
press down until it snaps into
place.
Transporting the Projector
The projector contains many glass and precision parts. Follow these
guidelines to prevent damage:
If you are moving the projector by hand, use the projector handle.
■
Attach the lens cover to the lens.
■
■
Return the projector feet to their stored (highest) positions.
Additionally, follow these guidelines when you are transporting the
projector a long distance:
■
Turn the vertical lens shift dial so that the lens is in its lowest
position.
■
When packing the projector, use the original packaging material if
possible, including the protective lens pads. If you do not have the
original packaging, use equivalent materials, placing plenty of
cushioning around the projector to protect it from shock.
ends as
–
caution
When replacing batteries,
take the following
precautions:
■
Replace the batteries as
soon as they run out. If the
batteries leak, wipe away
battery fluid with a soft
cloth. If fluid gets on your
hands, wash immediately.
■
Do not expose batteries to
heat or flame and do not put
them in water.
■
Dispose of used batteries
according to local
regulations.
■
Do not use batteries other
than those specified in this
User's Guide and do not
use batteries of different
types or mix old and new
batteries.
■
Keep these batteries out of
the reach of children.
Batteries are choking
hazards and are very
dangerous if swallowed.
note
Epson shall not be liable for
any damages incurred
during transportation.
Maintaining the Projector
93
Advertisement
Table of Contents
