Table of Contents
Advertisement
Enable if you want the projector to turn off
Sleep Mode:
automatically if it is idle and no signal is received for 1 to 30
minutes (you can adjust the amount of time using the next
setting).
Sleep Mode Timer:
period of time before the projector turns off automatically, from 1
to 30 minutes.
High Altitude Mode:
above 4,900 feet (1,500 meters) to ensure that the temperature is
regulated properly. Turn this setting off for lower elevations.
BNC Sync Termination:
(such as for switchers) is necessary.
Remote Control Type:
control provided with this projector, the PowerLite G5000, or the
PowerLite Pro G5150NL, G5350NL, G5200WNL,
Z8000WUNL, or Z8050WNL. Select
the remote control provided with a different Epson projector.
Inv Direction Button:
the ceiling to reverse the directions of the arrow buttons on the
projector's control panel.
■
Standby Mode
Select
Communication On
monitored over a network when it is in standby mode (the power
light is orange).
■
Air Filter Notice
Enable this option to receive a message on the screen when a clog
in the air filter is detected.
■
Projector ID
Lets you assign a numeric ID to each projector. When you are
using multiple projectors, you can use the ID to select the one you
want to operate with the remote control. See page 49 for
instructions.
When Sleep Mode is on, you can set the
Enable when you are using the projector
Enable when analog (75
Select
when you use the remote
Normal
Simple
Enable when the projector is mounted on
to enable the projector to be
Ω
) termination
if you want to use
Fine-Tuning the Projector
note
Do not use the projector at
altitudes above 9,800 feet
(3,000 meters).
note
You cannot use this
projector's remote control
when the
Remote Control
is set to
.
Type
Simple
Select this setting carefully as
changing it back may be
difficult if the projector is
mounted on the ceiling.
79
Advertisement
Table of Contents
