Table of Contents
Advertisement
■
Unplug the projector from the wall outlet and refer servicing to qualified
service personnel under the following conditions: if it does not operate
normally when you follow the operating instructions, or exhibits a
distinct change in performance; if smoke, strange odors, or strange
noises come from the projector; if the power cord or plug is damaged or
frayed; if liquid or foreign objects get inside the projector, or if it has
been exposed to rain or water; if it has been dropped or the housing has
been damaged.
■
Except as specifically explained in this User's Guide, do not attempt to
service this product yourself. Refer all servicing to qualified personnel.
Opening or removing covers may expose you to dangerous voltages and
other hazards.
■
Never open any covers on the projector except as specifically explained
in this User's Guide. Never attempt to disassemble or modify the
projector (including consumables). Refer all repairs to qualified service
personnel.
■
Use the type of power source indicated on the projector. Use of a
different power source may result in fire or electric shock. If you are not
sure of the power available, consult your dealer or power company.
■
If you use the projector in the country where it was purchased, only use
the power cable that came with the projector. If you use the projector in
a country other than where you purchased it, use the correct power cord
for that country.
■
Take the following precautions when handling the plug: Do not
overload wall outlets, extension cords, or power strips. Do not hold the
plug with wet hands. Do not insert the plug into a dusty outlet. Insert
the plug firmly into the outlet. Do not pull the power cord when
disconnecting the plug; always be sure to hold the plug when
disconnecting it. Failure to comply with these precautions could result
in fire or electric shock.
■
Do not place anything that can become warped or damaged by heat near
the exhaust vents. Do not bring your hands or face close to the vents
while projection is in progress.
■
Before you move the projector, make sure its power is turned off, the
plug is disconnected from the outlet, and all cables are disconnected.
■
Do not project images while the detachable lens cover is still attached.
Heat may cause the lens cover to melt, and if you touch the lens cover
you could get burned.
■
Do not block the light coming from the projector with any object. The
object may be damaged or the reflected light may heat the lens and
damage the projector.
Notices
125
Advertisement
Table of Contents
