Epson PowerLite Pro G5900 User Manual page 109

Make sure you are within about 49 feet (15 meters) of the
■
projector and within range of the projector's front or back sensor.
Dim the room lights and turn off any fluorescent lights. Make
■
sure the projector is not in direct sunlight. Strong lighting,
especially fluorescent lights, may affect the projector's infrared
receivers. Also, turn off any nearby equipment that emits infrared
energy, such as a radiant room heater. If necessary, use the
Remote Receiver
sensor if it continues to pick up interference (see page 72).
Make sure the
■
Remote Receiver
the projector's sensors (see page 72).
If any buttons are held for longer than 30 seconds, the remote
■
enters sleep mode. Release any button that is held to wake the
remote.
When the optional remote control cable is connected, the remote
■
control light-emitting area and the projector's remote receiver are
disabled. If you're not using the cable, make sure it is
disconnected from both the remote control and the projector.
■ Make sure the
Remote Control Type
page 78.
setting to disable the projector's front or back
setting isn't disabling both of
setting is correct. See
Solving Problems
109