Cartridge Change Maintenance Checklist Items; Changing An Appliance - Prolitec Air/Q 310 User Manual

Maintenance
5. Inspect the o-rings on the air stem for breakage or deterioration. Replace
as needed.
6. Remove the large plug and the plug from the Output Port you wish to use (top
or front), insert the new cartridge and replace the top blue tube or the front
output shroud if you are using them.
7. Place the exhausted cartridge in the recycle bin.

Cartridge Change Maintenance Checklist Items

• C artridge plume: Use a high-intensity flashlight or your headlamp to confirm that a
plume is streaming from the output port. If there is no plume:
• C heck that the other output port is plugged. It should be.
• C heck that the power is on and the appliance is running.
• C heck that the o-rings on the air stem are in place and not cracked or broken.
Replace if necessary.
• I f the dial is set to Program, switch it to 24/7 and check for a plume.
• I f no plume, set the dial back to Program and change the cartridge.
• I f still no plume, try another cartridge just to make sure. If no plume, replace the
appliance. (See Changing an Appliance below).
• Wipe the unit clean inside and out.

Changing an Appliance

Appliance malfunctions are not intended to be serviced in the field. If there is no
plume after following the procedure outlined above or there is any excessive noise
level, then the appliance must be replaced with a new one.
1. Open the door.
2. Using a Phillips screwdriver, unscrew the two bottom screws on the lower left
and right corners.
21