Prolitec Air/Q 310 User Manual page 14

Installation
Step 6 – Drilling the Bottom Anchor Holes
Drill a / " hole as the guide for the anchors at the exact spot you have marked.
1
8
Hammer the anchors in just enough to set them in place, then screw them
in straight.
Step 7 – Hanging the Mounting Bracket
Hang the mounting bracket by holding the bracket so the top holes match up with
the anchors, then screw the 2 flat-head screws through the hole in the bracket into
the anchors. Tighten the screws firmly, but do not crack the bracket.
Step 8 – Positioning the Appliance
Now take the appliance and pull out the yellow tab at the bottom.
Take the power supply and plug the round plug into the hole that is located in the
recess on the back of the appliance. The power-supply block can accommodate
several different plugs for every county. Install the correct one and plug it into the
wall receptacle.
12