Inserting The Cartridge; Setting The Clock - Prolitec Air/Q-100 Original Instructions Manual

Setting Up Air/Q

Inserting the Cartridge

1. Ensure power switch is off before inserting cartridge.
2. C artridge: remove screw-top cap, bottom red plug (save for future storage)
and foil seal. Insert cartridge, pressing firmly until cartridge sits in place (Fig. 1).
3. To activate cartridge: using a tissue or paper towel, press in the stem in the
center of the top output chimney; the stem should spring back (Fig. 2).
IMPORTANT: Power must be turned off before the
Air/Q cover is removed or replaced to prevent pres-
sure build-up in the cartridge. Also, power must be
turned off before moving Air/Q around to prevent pres-
sure build-up. Pressure could prevent fragrance from
properly pluming. In the event this should occur, sim-
ply reactivate the cartridge as shown in Fig. 2 above.

Setting the Clock

1. Turn the dial to Set Clock.
2. A djust using the + /– buttons.
™
Fig. 1 Fig. 2
11