Prolitec Air/Q 310 User Manual page 11

Installation
In some locations local codes or rules require that the main power source be
located beside the appliance. This will require an Air/Q
appliance is PERMANENTLY CONNECTED in this way, a readily accessible
disconnect device must be used. Consult with your electrician.
If it makes sense to plug the appliance into an outlet that is near but not behind the
appliance, a rectangular, plastic wire-concealment conduit should be used.
Step 2 – Mounting Kit, Parts and Tools
The mounting kit provided with Air/Q 310
(see details on pages 3-4) includes a mounting
plate, which holds the appliance to the wall,
and 4 screws and wall anchors suitable for
plastered drywall — 2 short flat-head screws
and 2 longer round-head screws. If you have
another surface you will need to get anchors
suitable for the wall material and screws that
work with these anchors. The screws need
to be the same length as the ones provided —
2 long round-head screws and 2 short flat-
head screws. You will need the following tools:
1. A good level to help you make the mounting plate exactly horizontal.
2. A hammer.
3. A Phillips screwdriver to match the screws provided or whatever screwdriver
matches the screws needed to attach to the anchors you have chosen.
4. A pointy tool like a small screwdriver to insert through the holes on the
appliance to mark the right spot for the anchors.
5. A Drill.
310 hardwiring kit. If the
™
9