Table of Contents
Advertisement
Error Message
No Response/Busy
Out of Fax Memory
Out of Memory
Paper Size Mismatch
Cause
The photo bypass tray is in the wrong
position.
The paper was not inserted in the center
position of the manual feed slot.
The Jam Clear Cover is not closed
correctly.
Paper dust has accumulated on the
surface of the paper pick-up rollers.
The number you dialed does not answer
or is busy.
The fax memory is full.
The machine's memory is full.
The paper size setting does not match the
size of paper in the tray.
-OR-
You did not set the paper guides in the
tray to the indicators for the paper size
you are using.
Action
Return the photo bypass tray to the
Normal printing position when you use cut
sheet paper.
See Related Information: Load Photo or
Photo L Paper in Photo Bypass Tray.
Remove the paper and reinsert it in the
center of the manual feed slot, and then
follow the on-screen instructions.
See Related Information: Load Paper in
the Manual Feed Slot.
Make sure the Jam Clear Cover is closed
evenly at both ends.
See Related Information: Printer Jam or
Paper Jam.
Clean the paper pick-up rollers.
See Related Information: Clean the Paper
Pick-up Rollers.
Verify the number and try again.
Do one of the following:
•
Clear the data from the memory. To
gain extra memory, you can turn off
Memory Receive.
See Related Information: Turn Off
Memory Receive.
•
Print the faxes that are in the memory.
See Related Information: Print a Fax
Stored in the Machine's Memory.
If a fax-sending or copy operation is in
progress:
•
Press
or Quit or Close and wait
until the other operations that are in
progress finish, and then try again.
•
Press Send Now to send the pages
scanned so far.
•
Press Partial Print to copy the
pages scanned so far.
•
Clear the data in the memory. To gain
extra memory, you can turn Memory
Receive off.
See Related Information: Turn Off
Memory Receive.
•
Print the faxes stored in the memory.
See Related Information: Print a Fax
Stored in the Machine's Memory.
1. Check that the paper size you selected
on the machine's display matches the
size of the paper in the tray.
See Related Information: Change the
Paper Size and Paper Type.
2. Make sure you loaded the paper in a
Portrait position, by setting the paper
guides at the indicators for your paper
size.
416
Advertisement
Table of Contents
