Table of Contents
Advertisement
Error Message
Low Temperature
Media card error
Media Error
Media is Full.
No Caller ID
No Device
(Wi-Fi Direct)
No File
No Ink Cartridge
No Paper Fed
Cause
The room temperature is too low.
Multiple data storage devices were in the
machine when it was turned on. The
machine can read only one memory card
or USB flash drive at a time.
The memory card is either corrupted,
incorrectly formatted, or there is a
problem with the memory card.
The memory card or USB flash drive you
are using already contains 999 files.
The memory card or USB flash drive you
are using does not have enough free
space to scan the document.
There is no incoming call history. You did
not receive calls or you have not
subscribed to the Caller ID service from
your telephone company.
When configuring the Wi-Fi Direct
network, the Brother machine cannot find
your mobile device.
The memory card or USB flash drive in
the media drive does not contain a .JPG
file.
An ink cartridge is not installed correctly.
The machine is out of paper or paper is
not correctly loaded in the paper tray.
Action
After warming the room, allow the
machine to warm up to room temperature.
Try again when the machine has warmed
up.
Remove the memory cards or USB flash
drives that you are not using.
Remove the memory card from the media
drive (slot) of the machine and format it
correctly.
Put the card firmly into the slot again to
make sure it is in the correct position. If
the error remains, check the media drive
(slot) of the machine by putting in another
memory card that you know is working.
Your machine can only save to your
memory card or USB flash drive if it
contains fewer than 999 files. Delete
unused files and try again.
Delete unused files from your memory
card or USB flash drive to make some
free space, and then try again.
To use the Caller ID feature, call your
telephone company.
See Related Information: Caller ID.
•
Make sure your machine and mobile
device are in the Wi-Fi Direct mode.
•
Move the mobile device closer to your
Brother machine.
•
Move your Brother machine and the
mobile device to an obstruction-free
area.
•
If you are manually configuring the
Wi‑Fi Direct network, make sure you
have entered the correct password.
•
If your mobile device has a
configuration page for how to obtain
an IP address, make sure the IP
address of your mobile device has
been configured via DHCP.
Put the correct memory card or USB flash
drive into the slot again.
Remove the new ink cartridge and re-
install it slowly and firmly until it locks into
place.
See Related Information: Replace the Ink
Cartridges.
Do one of the following:
•
Refill the paper tray, and then follow
the on-screen instructions.
•
Remove and reload the paper, and
then follow the on-screen instructions.
See Related Information: Load Paper.
415
Advertisement
Table of Contents
