Inkbox Nearfull; No Ink Cartridge - Brother MFC-J200 User Manual

Error Message

InkBox NearFull

Ink Low XXXXXXX
Low Temperature

No Ink Cartridge

No Paper Fed
60
Cause
The ink absorber box or flushing box
is nearly full.
One or more of the ink cartridges are
near the end of their life. If one of the
colour ink cartridges is near the end
of its life and someone is sending you
a colour fax, your machine's
"handshake" will ask that the fax be
sent in monochrome. If the sending
machine has the ability to convert it,
the colour fax will be printed at your
machine as a monochrome fax.
The room temperature is too low.
An ink cartridge is not installed
correctly.
The machine is out of paper or paper
is not correctly loaded in the paper
tray.
The paper tray was not fully inserted. Remove the paper tray and re-install
Paper dust has accumulated on the
surface of the paper pick-up rollers.
The Jam Clear Cover is not closed
correctly.
The paper is jammed in the machine. Remove the jammed paper by
Action
Contact Brother customer service or
your local Brother dealer.
Order a new ink cartridge. You can
continue printing until the LCD shows
Cannot Print. (See Replacing the
ink cartridges on page 48.)
After increasing the room
temperature, allow the machine to
warm up to room temperature and
then try again.
Take out the new ink cartridge and
re-install it slowly and firmly until the
cartridge lever lifts. (See Replacing
the ink cartridges on page 48.)
Do one of the following:
 Refill the paper in the paper tray,
and then press Mono Start or
Colour Start.
Remove and reload the paper,

then press Mono Start or
Colour Start. (See Loading
paper and other print media
on page 10.)
it until it locks into place, and then
press Mono Start or Colour Start on
the control panel.
Clean the paper pick-up rollers.
(See Advanced User's Guide:
Cleaning the paper pick-up rollers.)
Make sure the Jam Clear Cover is
closed evenly at both ends. (See
Printer jam or paper jam on page 65.)
following the steps in Printer jam or
paper jam on page 65.
If this error occurs often during
2-sided printing, the paper feed
rollers may be stained with ink. Clean
the paper feed rollers.
(See Advanced User's Guide:
Cleaning the paper feed rollers.)