Table of Contents
Advertisement
Installation
Preparing the worktop
^ Make the worktop cut-out following
the dimensions applicable.
Remember to maintain a minimum
safety distance from the back wall,
as well as from any tall unit or side
wall to the right or left of the cooktop.
See "Safety clearances".
^ Seal the cut surfaces with a suitable
heat-resistant sealant to avoid
swelling caused by moisture.
If, during installation, you find that the
seals on the corners of the frame are
not flush with the worktop, the corner
radius ß R4, can be carefully scribed
to suit.
These cooktops have a seal
underneath them to keep the cooktop
securely in position. Clamps are not
required.
Any gap between the frame and
worktop will reduce with time.
50
Installing the cooktop
^ Feed the cooktop connection cable
down through the cut-out.
^ Place the cooktop centrally in the
cut-out. When doing this make sure
that the seal under the cooktop sits
flush with the worktop on all sides.
This is important to ensure an
effective seal all round. Do not use
sealant.
^ Connect the cooktop to the mains.
^ Check that the cooktop works.
Hide quick links:
Advertisement
Table of Contents
