Installing The Cooktop Flush With The Worktop - Miele KM 7404 FX Operating And Installation Instructions

Installing the cooktop flush
with the worktop
 Create the worktop cut-out.
Remember to maintain the minimum
safety distances (see "Installation –
Safety distances").
 Solid wood, tiled and glass worktops:
Fix a wooden frame 5.5 mm or 7 mm
(KM 7404 FX, KM 7414 FX,
KM 7414 FX Glas) below the top
edge of the worktop.

Risk of damage from incorrect
connection.
The electronics of the cooktop may
be damaged if a short-circuit occurs.
The mains connection cable must be
connected to the cooktop by a
qualified electrician.
 Connect the mains connection cable
by following the instructions in the
wiring diagram on the cooktop (see
"Installation – Electrical connection").
 For all cooktops, apart from the
following models: KM 7404 FX,
KM 7414 FX, KM 7414 FX Glas,
attach the sealing strip provided
underneath the edge of the cooktop.
Do not apply the sealing strip under
tension.
 Feed the mains connection cable
down through the worktop cut-out.
The gap between the ceramic glass
surface and the worktop must be at
least 2 mm wide. This is required so
that the cooktop can be sealed.
 Centre the cooktop in the cut-out.
 If a base panel optimised for air
intake has been installed, position the
cooktop so that the fans sit above the
cut-outs.
 Connect the cooktop to the electricity
supply (see "Installation – Electrical
connection").
 Check that the cooktop works.
 Seal the gap between the cooktop
and worktop with a silicone sealant
that is heat-resistant to at least
160 °C.
Installation
89