Electrical Connection - Miele KM 5731 Operating And Installation Instructions

Installation

Electrical connection

All electrical work should be carried
out by a suitably qualified and
competent person, in strict
accordance with national and local
safety regulations.
Installation, repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
Ensure power is not supplied to the
appliance while installation work is
being carried out.
The appliance must only be
operated when built-in. This is to
ensure that all electrical parts are
shielded. Live parts must not be
exposed.
After the appliance has been built in,
a check must be made that all
electrical parts are shielded.
The voltage and connected load are
given on the data plate. Ensure that
these match the household mains
supply.
Connection should be made via a
suitable isolator, which complies with
national and local safety regulations
and which is easily accessible after the
appliance has been built in.
For extra safety it is advisable to install
a residual current device (RCD), with a
trip current of 30 mA.
52
Test marks
Electrically suppressed according to
AS/NZS 1044
Important
The appliance is supplied for
connection to an a.c. single phase
230-240 V, 50 Hz supply with a 3-core
cable.
The wires in the mains lead are
coloured in accordance with the
following code:
Green/yellow = earth
Blue = neutral
Brown = live
WARNING
THIS APPLIANCE MUST BE
EARTHED
The electrical safety of this appliance
can only be guaranteed when
continuity is complete between the
appliance and an effective earthing
system, which complies with local and
national regulations. It is most important
that this basic safety requirement is
regularly tested and if there is any
doubt, the electrical wiring in the home
should be inspected by a qualified
electrician. The manufacturer cannot be
held liable for the consequences of an
inadequate earthing system such as an
electric shock.
The manufacturer cannot be held
liable for damage which is the direct
or indirect result of incorrect
installation or connection.
Electrical safety,
C-Tick Mark