Installation
Preparing the worktop
Create the worktop cut-out.
Remember to maintain the minimum
safety distances (see "Safety
distances").
Seal the cut surfaces of wooden
worktops with a suitable heat-
resistant sealant to avoid swelling
caused by moisture. The sealant
must be temperature-resistant.
Make sure the sealant does not
come into contact with the top
surface of the worktop.
Flush-fit installation
For wooden worktops, secure the
wooden frames 5.5 mm below the
upper edge of the worktop.
For CS 7611 FL, the wooden frame
must be secured 7 mm under the
upper edge of the worktop.
64
Fitting the spacer bars
Use the middle screw holes if one of the
following SmartLine appliances is
installed to the right or left of the spacer
bar: CS 7611, CS 7101, CS 7102
Wooden worktops
Position the spacer bars flush onto
the upper edge of the cut-out or onto
the lower step of the stepped cut-out.
Secure the spacer bars with the
3.5 x 25 mm wood screws supplied.