Use; Sensors; Switching On - Miele KM 5731 Operating And Installation Instructions

Sensors

This cooktop is equipped with
electronic sensor controls which react
to finger contact.
To operate a cooking zone touch the
relevant sensor control. Each time you
touch a sensor control an audible tone
sounds.
Make sure that only one sensor is
touched at a time (except when
switching off a cooking zone) and
keep the control area clean and do
not put things down on it. The
sensors may fail to react or they
could mistake the article or any dirt
for a finger tip contact, thereby
activating a function or even causing
the cooktop to switch off
automatically (see "Safety
switch-off".)
Never place hot pans over the
sensors. The electronic unit
underneath could get damaged.

Switching on

The cooktop must be switched on
before any of the zones can be used.
Do not leave the appliance
unattended whilst it is being used.
To switch the cooktop on:
^ Touch the ON/OFF sensor s.
A 0 appears in the display for each of
the zones. If no further entry is made,
the cooktop will switch itself off after a
few seconds for safety reasons.
To switch a cooking zone on:
^ Select a power setting between 1 and
9 by touching the - or + sensor.
To select cooking with Auto heat-up,
press the - sensor first, see "Auto
heat-up". To select cooking without
Auto heat-up press the + sensor first.
If you wish to switch on another
cooking zone, and the 0 for that zone
has already gone out, press the - or +
sensor briefly. The 0 will appear and
you can select a power setting (with or
without Auto heat-up).

Use

21