Problem Solving Guide - Miele KM 5731 Operating And Installation Instructions

Installation work and repairs to
electrical components of this
appliance must only be carried out
by a suitably qualified and
competent person in accordance
with local and national safety
regulations. Repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
Ensure that current is not supplied
tothe appliance until after
maintenance or repair work has
been carried out.
What to do if, ...
... the cooktop or cooking zones
cannot be switched on
Check whether,
– the pans in use are suitable.
– the safety lock is activated.
If necessary, deactivate it (see
"Safety lock" and "Programming -
P4").
– the mains fuse has blown.
If none of the above is the case, then
disconnect the appliance from the
electricity supply for approx. 1 minute.
To do this:
– switch off at the isolator, or
– withdraw the mains fuse.
Reconnect to the mains supply and
switch the appliance on. If it still will not
start, contact a qualified electrician or
the Miele Customer Contact Centre.

Problem solving guide

... the cooktop can be switched on
and settings selected, but the
cooking zones do not heat up
Check whether you set the demo-mode
setting by mistake (see "Programming -
P0").
... a ß appears in the display for a
cooking zone
– Check whether the zone was
switched on by mistake without a
pan on it.
– Check whether the pan being used is
suitable for use on an induction zone
(see section "Pans").
... a cooking zone or the cooktop
switches off while it is in use
One of the safety switch-off features
has been activated (see section on
"Safety switch-off" and "Overheating
protection").
39