Connecting The Battery Pack; Fitting The Trim; Fitting The Fender - Flavel Windsor Installation, Maintenance & User Instructions

3.3 CONNECTING THE BATTERY PACK (EFC MODELS)
a) To prevent un-necessary battery drain, the battery pack that is
used to provide the remote control function for this product is
disconnected at the factory. Prior to attempting to light the product, can
the installer please ensure that the battery pack is re-connected as
shown in section b), c) & d) below.
b) Locate the battery pack in the support cradle at the bottom R/H side of
the firebox / burner assembly.
c) The wire and connecting plug from the battery pack should then be
connected into the supply wire running from the control board. See
figure 18 below.
Fig. 18
d) Replace the battery pack into its mounting cradle below the burner.
3.4

FITTING THE TRIM

a) The trim is held in position on the fixing flange by magnets.
3.5

FITTING THE FENDER

a) The fender is placed up to the front of the ceramic front rail on
all models. Position the ashpan under the fender and centralise.
Battery
pack
Connecting wire
Connecting
plug
22