Table of Contents
Advertisement
4.2.5
Remove the valve retaining screws and remove the valve. Re-assemble
in reverse order and carry out a gas tightness test. Re-fit the "Kamina"
fascia as described in section 3.3 on page 19.
4.3
Removing the Pilot Assembly.
Note : Because this appliance is fitted with an atmosphere sensing 'Oxy-
Pilot' it is not possible to replace the thermocouple separately, because the
thermocouple position is factory set to a tight tolerance. Any replacement of
parts on the pilot requires a complete new pilot assembly.
4.3.1
Prepare work area (lay down dust sheets etc.)
4.3.2
Remove the "Kamina" fascia from the product as shown in section 3.3
on page 19 and put it in a safe location.
4.3.3
Remove the glass frame assembly as shown in section 3.4 on page 20
and put it in a safe location.
4.3.4
Loosen the pilot nut and remove the two screws retaining the pilot
assembly. Unscrew the thermocouple from the gas valve.
4.3.4
Re-assemble in reverse order and carry out a gas tightness test and
re-fit the glass frame assembly as shown in section 3.4 on page 20 and
the "Kamina" fascia as described in section 3.3 on page 19.
4.4
Replacing the Batteries (Within the Radio Frequency Receiver)
4.4.1
Prepare work area (lay down dust sheets etc.)
4.4.2
Remove the "Kamina" fascia from the product as shown in section 3.3
on page 19 and put it in a safe location.
4.4.3
The RF receiver is located in the centre of the product, below the burner
assembly. Unscrew the retaining screw and remove the RF receiver.
Slide the battery cover off and replace the batteries as necessary.
4.4.4
Replace the "Kamina" fascia as described in section 3.3 on page 19.
4.4.5
Replace in reverse order and check correct operation of the appliance.
NB
The handset uses one LR61 (9v) and should be replaced by
removing the cover on the rear of the handset.
ENSURE THE BATTERIES ARE CONNECTED TO THE CORRECT POLARITY
POSITVE (+), NEGATIVE (-)
22
Advertisement
Table of Contents
