Table of Contents
Advertisement
6-3
Accessing the Inside of the System
Performing maintenance on componenets such as fans requires access to the inside
of the server system. Follow the steps below to remove the top/left side cover to
gain access to the inside of the 6048R-TXR.
If the system has been installed to a rack, carefully pull it out on the rails until the
top cover is exposed. Powered must be removed from the system before working
on or replacing some components (refer to following sections in this chapter).
1. Remove the screw at the rear of the chassis and set it aside for later use.
2. Remove the two screws on the sides of the cover and set them aside.
3. Lift the cover up and off the chassis.
Figure 6-2. Accessing the Inside of the System
1
3
Chapter 6: Advanced Chassis Setup
1
2
6-3
1
1
1
2
Advertisement
Table of Contents
