Table of Contents
Advertisement
PQQX14041ZA.book 71 ページ ２００４年２月２０日 金曜日 午後３時３分
Troubleshooting
If the handset display shows error messages, see "If the Following Appears
on Your Display..." (p. 69–70) for the Cause & Remedy.
Telephone System
Problem
"No link to base. Move
closer to base, try
again." is displayed and an
alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from other
electrical units.
The handset does not ring.
The handset display is blank.
You cannot program any
function items.
While programming or
searching, the handset starts
to ring and the program/
search stops.
You cannot make an intercom/
outside call.
Cause & Remedy
• You are too far from the base unit. Walk
closer to the base unit.
• Confirm the base unit's AC adaptor is
plugged in.
• Raise the base unit antenna.
• If the above remedies do not solve the
problem, the handset may have lost
communication with the base unit. Register
the handset again (p. 53).
• Move the handset and base unit away from
other electrical appliances (p. 3).
• Walk closer to the base unit.
• Raise the base unit antenna.
• The ringer volume is turned off. Set to high,
medium, or low (p. 18).
• If only the handset display is blank, fully
charge the battery (p. 10).
• Programming is not possible while the
handset and/or base unit is being used.
• Do not pause for over 60 seconds while
programming.
• Walk closer to the base unit.
• While another user is listening to messages
or the Answering System is handling a call,
you cannot program. Try again later.
• A call is coming in. To answer the call, press
[C] or [s]. Try again from the beginning
after hanging up.
• Your handset is in remote operation mode
(p. 57). Exit by pressing [OFF].
• The handset you called is too far from the
base unit.
• If the handset or base unit is in use, you may
not be able to make a call. Try again later.
71
Advertisement
Table of Contents
