Table of Contents
Advertisement
Troubleshooting guide
Cordless telephone
Static, sound cuts in and out,
fades. Interference from other
unit.
—Electrical interference may
cause static and poor range
Set the portable handset and
the base unit away from other
electric appliances.
—You may be too far from the
base unit. Approach it.
—Extend the antennas of the
base unit and the portable
handset fully.
—Change the channel.
When | press the TALK button
to make a call, 3 beeps sound
and "DIEI" is displayed.
—Approach the base unit and try
again.
—Place the portable handset on
the base unit and try again.
— Маке sure that the AC adaptor
is connected.
The portable handset does not
ring.
—The POWER/RINGER switch
is in the OFF position. Set to
the ON position.
The base unit does not ring.
—The RINGER selector is in the
OFF position. Set to the HIGH
or LOW position.
When I press the INT'/PAGE
button, 3 beeps sound and
paging cannot be done.
— Paging cannot be done while
the base unit is receiving an
incoming call or recording
some messages.
— You are too far from the base
unit. Approach it.
| cannot page the portable
handset from the base unit.
— Paging cannot be done while
the base unit is receiving an
incoming call or recording
some messages.
—Set the POWER/RINGER
Switch to the ON position.
1 cannot store a phone number
into memory.
— You cannot store the number
in memory while the unit is in
the talk mode or in the
intercom mode.
— Do not pause for over
30 seconds while sloring.
While storing a phone number,
the unit starts to ring.
— You can answer the call by
pressing the TALK or
SP-PHONE button. The
program will be canceled;
store the phone number again.
A beep sounds every
15 seconds during a
conversation.
— Charge the battery fully.
(See page 3.)
Advertisement
Table of Contents
