Table of Contents
Advertisement
PQQX14041ZA.book 11 ページ ２００４年２月２０日 金曜日 午後３時３分
Recharge
Recharge the battery when:
—"Recharge battery" is displayed on the handset,
—"7" flashes, or
—the handset beeps intermittently while it is in use.
• The display will continually indicate that "Recharge battery" and/or "7" will
flash when the handset battery is charged for less than 15 minutes and the
handset is lifted off the base unit or charger.
• If the battery has been discharged, the handset will display "Charge for 6h"
and "8" when you place the handset on the base unit or charger. The handset
will not work unless the battery is charged. Continue charging.
Battery replacement:
If you cleaned the charge contacts and fully charged the battery, but after a few
telephone calls, "Recharge battery" is displayed and/or "7" continues to
flash, or "Charge for 6h" and "8" are displayed, the battery may need to
be replaced. Please replace with a new Panasonic HHR-P104 battery. To
replace the battery, see page 10.
A nickel metal hydride battery that is recyclable powers the
product you have purchased. Please call 1-800-8-BATTERY for
information on how to recycle this battery.
Battery information
After your Panasonic battery
is fully charged, you can
expect the following
performance:
• A fully charged battery will give you up to 5 hours of continuous talk time, or keep
your handset in Standby mode to receive incoming calls for up to 11 days (if no
phone calls are made). Battery power is consumed whenever the handset is off of
the base unit or charger, even when the handset is not in use. The longer you
leave the handset off of the base unit or charger, the time you can actually talk on
the handset will be shortened. Actual battery performance depends on a
combination of how often the handset is in TALK mode and how often it is in
Standby mode.
• Clean the charge contacts of the handset, the base unit and the charger with
a soft, dry cloth once a month. Clean more often if the unit is subject to
grease, dust or high humidity, otherwise, the battery may not charge properly.
• If the battery is fully charged, you do not have to place the handset on the base
unit or charger until "Recharge battery" is displayed and/or "7" flashes.
This will maximize the battery life.
• If you want to keep the battery fully charged at all times, place the handset on the
base unit or charger when the handset is not used. The battery cannot be
overcharged.
Operation
While in use (TALK)
While not in use (Standby)
Installation
Recharge battery
Operating time
Up to 5 hours
Up to 11 days
11
Advertisement
Table of Contents
