Table of Contents
Advertisement
Lights and visibility
Lights
Introduction
This chapter contains information on the following subjects:
Operating the lights
Unless otherwise stated, the lights only work when the ignition is switched on.
The arrangement of the controls right-hand drive models may differ from the
layout shown in
» Fig. 52
on page 69. The symbols which mark the positions
of the controls are identical.
Keep the headlights lenses clean
WARNING
The activation of the lights should only be undertaken in accordance with
■
national legal requirements.
The automatic driving lamp control only operates as a support and
■
does not release the driver from his responsibility to check the lights and, if
necessary, to switch on the light depending on the prevailing light condi-
tions.
» page
197, Headlight glasses.
Note
The headlights may mist up temporarily. When the driving lights are switched
■
on, the light outlet surfaces are free from mist after a short period, although
the headlight lenses may still be misted up in the peripheral areas. This mist
has no influence on the life of the lighting system.
If the visibility is poor and the lights are not on (except daytime running light)
■
the brightness of the instrument lighting reduces to alert the driver to switch
on the lights in due time.
69
The brightness of the instrument lighting with the lights on (except daytime
■
70
running lights) can be set in the Infotainment
70
tainment, chapter CAR - Vehicle Settings.
71
71
Operating the lights
72
72
73
73
73
73
74
Read and observe
Switching lights on and off
Depending on the equipment configuration, the light switch
turned to one of the following positions.
Switching off lights (except daytime running lights)
Automatic switching of lights on and off
Switching on the parking light or parking light
Switching on the low beam
Headlight range control
Turn the dial
» Fig. 52
from position to to gradually adjust the headlight
B
range control and shorten the light cone.
The positions of the width of illumination correspond approximately to the fol-
lowing car load.
Front seats occupied, boot empty
All seats occupied, boot empty
»
Operating instructions Info-
Fig. 52
Light switch and control dial for
the headlight beam range regu-
lation
on page 69 first.
» page 71
» page 73
Lights and visibility
» Fig. 52
can be
A
69
Advertisement
Chapters
Table of Contents
