Table of Contents
Advertisement
Lights and visibility
Lights
Introduction
This chapter contains information on the following subjects:
Side lights and low beam
WARNING
The activation of the lights should only be undertaken in accordance with
■
national legal requirements.
The driver is always responsible for the correct settings and use of the
■
lights.
Never drive with only the side lights on! The side lights are not bright
■
enough to light up the road sufficiently in front of you or to be seen by other
oncoming traffic. Therefore always switch on the low beam when it is dark or
if visibility is poor.
Notice
The headlights may mist up temporarily. When the driving lights are switched on,
the light outlet surfaces are free from mist after a short period, although the
headlight lenses may still be misted up in the peripheral areas. This mist has no
influence on the life of the lighting system.
Side lights and low beam
23
24
24
25
ings
on page 23.
25
light switch
positions» fig. 15
A
Switching off all lights
Switching on side lights
Turn on the low beam
Switch on the front fog lamp
Switching on the rear fog light
Turning the rotary switch from position
gradually adjusted and thereby shortens the light cone.
The positions of the width of illumination correspond approximately to the fol-
lowing car load.
Front seats occupied, boot empty
All seats occupied, boot empty
All seats occupied, boot loaded
Driver seat occupied, boot loaded
WARNING
Always adjust the headlight beam to satisfy the following conditions.
The vehicle does not dazzle other road users, especially oncoming vehicles.
■
The beam range is sufficient for safe driving.
■
Fig. 15
Light switch and control dial for
the headlight beam range regu-
lation
» page 24
» page 25
in the headlight adjustment is
B
23
Advertisement
Chapters
Table of Contents
