Operation Overview; Start Control - Skoda Superb B8 Owner's Manual

Starting to drive again after a holding period
As soon as the vehicle ahead starts moving again after a holding period, your
vehicle will also move and the speed will continue to be regulated.
If the preceding vehicle starts moving again after a long break, then to contin-
ue the regulation press the accelerator pedal or lever to position ad-
just» page

166, Operation Overview.

Operation Overview
Fig. 202 Operating lever

Read and observe on page 163 first.
Overview of ACC functions operated with the lever
   Set proximity level
A
Start control (adopt current speed) / Reduce speed by 1 km/h at
B

a time
Activate ACC (regulation deactivated)
1

Start control (resume) / increase speed by 1 km/h at a time
2

(sprung position)
Interrupt control (sprung position)
3

Deactivate ACC
4

Increase speed by 10 km/h at a time
5
 
Decrease speed by 10 km/h at a time
6  
Note
If the lever is set » Fig. 202 from the position  directly into the sprung posi-
tion,  the current speed is stored and the control process is started.
166
Driving

Start control


Basic requirements for start of control





The control be started with the key  or by adjusting the lever 
» Fig. 202
Button 
›
Press the button  .
The ACC will adopt the current speed and execute control.
Lever position 
›
Set the lever into the sprung position  .
The ACC will adopt the current speed and execute control. Should the speed
» Fig. 202
be stored already, the ACC adopts this speed and executes control.
The warning light
is switched on.
If control is started at a speed of less than 30 km/h on vehicles with an auto-
■
matic transmission, the speed of 30 km/h is stored. The speed increases auto-
matically to 30 km/h or is regulated with respect to the speed of the vehicle
ahead.
When TCS is disabled, it will be activated automatically upon starting control.
■
If the TCS is deactivated during control, control is stopped automatically.
■
Read and observe on page 163 first.
The ACC is activated.
The TCS is activated » page 143, Braking and stabilisation systems.
On vehicles with a manual transmission, the second gear or higher must
be engaged.
On vehicles with an automatic transmission, the selector lever must be in
the D/S position or in the Tiptronic position.
On vehicles with a manual transmission, the current speed must be higher
than approx. 25 km/h.
on page 166 into the sprung position.
illuminates in the instrument cluster when the regulation

Note