Climatronic (Automatic Air Conditioning) - Skoda Superb B8 Owner's Manual

Note
When the air distribution control is turned to position  the cooling system
■
is activated.
The warning light below the button 
■
even if not all of the conditions for the function of the cooling system have
been met. The lighting up of the indicator light in the button signals the opera-
tional readiness of the cooling system.
During operation of the manual air conditioning, an increase in engine idle
■
speed may occur under certain circumstances in order to ensure sufficient
heating comfort.

Climatronic (automatic air conditioning)

Fig. 153 Front operating elements
1)
Applies to left-hand drive vehicles.
2)
Applies to right-hand drive vehicles.
122
Using the system
» Fig. 152 illuminates after activation,
Fig. 154
Rear operating elements

Read and observe and
The Climatronic in automatic mode ensures the best-possible setting of the
temperature of the out-flowing air, the blower stage and air distribution.
Individual functions can be set off or on by turning the knob or pressing the
corresponding button. When the function is switched on, a control lamp illumi-
nates inside or below the button.
Some functions can also be operated in the infotainment
tions Infotainment, chapter Adjustment of the heating and cooling system.
Functions of the individual controls
Adjust the temperature for the left side (if applicable for the entire vehicle
A
interior)
1)
›
Lower temperature

›
Increase temperature

Interior temperature sensor
B
Adjust fan speed (the setting is indicated by the number of illuminated
C
control lamps shown in the knob)
›
Turn to the left: Reduce speed up to turning off the Climatronic
›
Turn to the right: Increase speed
Set the temperature for the right-hand side (if necessary set for the entire
D
vehicle interior)
2)
›
Lower temperature

›
Increase temperature

Display the temperature setting for the left side
E
Display the temperature setting for the right side
F
Depending on equipment fitted:
G
›
 Auxiliary heating and ventilation on / switch off
›
 Residual heat function on/off - after switching off the Ignition, the
remaining heat from the engine is used to continue heating the vehicle
interior for about 30 minutes
Adjust rear temperature - the operating elements can be locked in the In-
H
fotainment with the function key 
tainment, chapter Setting the heating and the cooling system.
›
Lower temperature

›
Increase temperature

on page 121 first.
» Operating instruc-
» Fig. 153 and » Fig. 154
» page 126
»
» Operating instructions Info-
