Table of Contents
Advertisement
Electrically operated sunshade
Read and observe
and
Operation of the sunblind
» fig. 54
Open - by pressing (press again - sunshade stops moving)
Close - by pressing (press again - sunshade stops moving)
The sunshade can also be operated by pressing and holding the appropriate
button (starts movement of the sunshade) and releasing it when the sunshade
reaches the desired position.
Activating operation of the sunshade
Read and observe
and
If the operation of sunshade is deactivated (e.g. after disconnecting and con-
necting the battery), then the operation will have to be activated.
›
Switch on the ignition, press and hold the
The sunshade opens and closes again after around 10 seconds.
›
Release the button.
64
Using the system
Fig. 54
Buttons for operating the sun-
shade
on page 62 first.
on page 62 first.
» fig. 54
on page 64 button.
Lights and visibility
Light
Introduction
Unless otherwise stated, the lights only work when the ignition is switched on.
For the basic position of the light switch, use position .
Notice
The headlights may mist up temporarily. When the light is switched on, the
light-emitting surface demists after a short period of time.
Operating the lights
To switch on/off the lights, turn the
positions (equipment-dependent).
Switching off lights (except daytime running lights)
Switching the light on/off automatically
Switching on the parking lights or parking lights on both sides
Switching on the low beam
Headlight range control of the Halogen headlights
The headlight range can be set in Infotainment in the menu
The range of the halogen headlights can be set on the screen, in accordance
with the vehicle load, to the following basic settings.
Front seats occupied, boot empty
All seats occupied, boot empty
Fig. 55
Light switch
» fig. 55
switch to one of the following
A
» page 66
» page 68
/ → → Light.
Advertisement
Table of Contents
