Removable Light; Class N1 Vehicles - Skoda Superb B8 Owner's Manual

Removable light

Fig. 142 Removable lamp: Remove / install

Read and observe and
The removable lamp (hereinafter referred to as a lamp) is located on the left
side of the luggage compartment.
The lamp is for the illumination of the luggage compartment or it can be used
as a portable lamp.
The lamp is fitted with magnets. Thus after taking these out of the vehicle
they can for example be connected to the car body.
Description of the lamp » Fig. 141
Button for operating the lamp
A
Part that lights up when the lamp is in the mount
B
Part that lights up when the lamp is not in the mount
C
Lamp placed in the mount
The warning light turns on when tailgate is opened.
116
Using the system
Fig. 141
Removable lamp
on page 108 first.
The warning light turns off when the tailgate is closed.
Removed from the holder
›
Grasp the lamp and swivel in the direction of the arrow
D
Use of removed light
›
Press the button » Fig. 141 - the lamp lights up.
A
›
Press button once again - the light goes out.
A
Reinserting the lamp the holder
›
Switch off the ignition » .
›
First insert the rear part of the lamp with the part
mount and then to press in the direction of the arrow
clicks into place.
Lamp charges
The lamp is supplied by three rechargeable type NiMH AAA batteries.
The rechargeable batteries are constantly charged when the engine is running.
It takes approx. 3 hours to fully charge the rechargeable batteries.
Replace batteries » page 235.
CAUTION
If the lamp is not switched off and it is correctly inserted in the holder, the
■
LED diodes in the front part of the lamp
off.
If the lamp is not correctly inserted into the holder, this does not light up
■
when the boot lid is opened and the rechargeable batteries are not charged.
The lamp is not watertight and must therefore be protected against mois-
■
ture.

Class N1 vehicles


Read and observe and
In class N1 vehicles that are not fitted with a protective grille, a lashing set that
complies with the EN 12195 standard (1-4) must be used for fastening the load.
Proper functioning of the electrical installation is essential for safe vehicle op-
eration. It is important to ensure that the electrical installation is not damaged
during the adjustment process or when the storage area is being loaded and
unloaded.
» Fig.
1
» Fig. 142 into the
E
, until it audibly
2
» Fig. 141 are automatically switched
C
on page 108 first.
142.