Skoda Superb B8 Owner's Manual page 78

In the following cases, the automatic adjustment of the cone of light of the
headlights is disabled, the system automatically switches only the high beam
on/off.
›
The driving mode Eco is selected
mode(Driving Mode Selection).
›
The driving mode Travel mode is selected
In the following case the Dynamic Light Assist is disabled.
›
The system is in rain or fog mode
WARNING
The system only serves as a support and does not relieve the driver of his
or her responsibility to check the headlights and low beam and, if necessa-
ry, to switch on the lights depending on the light conditions. The manual
operation may be required for example, in the following situations.
When visibility is poor, e.g. fog, heavy rain, or thick snowfall.
■
Passing poorly lit road users, e.g. cyclists or pedestrians.
■
When driving around "sharp" bends.
■
Driving through poorly-lit locations.
■
The camera viewing range is obstructed by an obstacle.
■
CAUTION
Do not attach any stickers or similar objects to the windscreen to avoid impair-
ing the functions of the systems.
Function

Read and observe and
Operating conditions
The system works under the following conditions.
The light switch is in the position .

The system is activated.

The system is activated » page

The vehicle speed is over 60 km / h or for some countries more than 40

km / h.
The headlight switches off automatically when the speed falls below 30 km/h.
The system can be activated/deactivated in the Infotainment
structions Infotainment, chapter CAR - vehicle settings.
» page 172, Selection of the driving
» page 72, travel mode.
» page 71, Xenon headlight.
on page 75 first.
75, Switching on and off.
» Operating in-
Switching on and off

Read and observe and
Switching on
›
Place the lever in position (spring-tensioned position)
A
The instrument cluster illuminates the warning light  of the systems switch-
ed on.
Switching off
›
If the headlight is switched on automatically, move the lever into position
(spring-tensioned position) » Fig.
The warning light  goes out. The high beam turns off.
›
If the headlight is not currently switched on automatically, move the lever in-
to position (spring-tensioned position) .
A
The warning light  goes out. The high beam turns on.
Information messages

Read and observe and
The messages and information are indicated in the instrument cluster display.
Fault: Light Assist

LIGHT ASSIST FAULT

Seek help from a specialist garage.
Light Assist: clean the windscreen!

WINDSCREEN PLEASE CLEAN

Check for any obstacles on the windscreen in the viewing area of the camera.
Fig. 58
Operating lever: Headlamp assis-
tant
on page 75 first.
» Fig. 58.
58.
on page 75 first.
Lights and visibility
B
75