Speed Limiter - Skoda Superb B8 Owner's Manual

Automatic control interruption
Automatic control interruption occurs if any of the following conditions are
met.
›
The brake pedal is operated.
›
When one of the brake assist systems (e.g. ESC) intervenes.
›
Through an airbag deployment.
›
By pressing the button » Fig.
D
WARNING
Always deactivate the cruise control system after use to prevent the sys-
■
tem being switched on unintentionally.
Control may only be resumed if the set speed is not too high for the cur-
■
rent traffic conditions.
Note
During control, speed can be increased by pressing the accelerator pedal. Re-
■
leasing the accelerator pedal will cause the speed to drop again to the set
speed.
By pressing the button » Fig. 195
D
■
and the Speed Limiter is activated.

Speed limiter


Introduction
This chapter contains information on the following subjects:
Operation
Operation description
The Speed Limiter limits the maximum driving speed to the set speed limit.
This limit can only be exceeded by depressing the accelerator pedal fully.
The condition in which the Speed Limiter monitors a potential set speed limit
excess is referred to as Regulation.
WARNING
The speed limiter only serves as an assistance and does not relieve the
■
driver of the responsibility for the vehicle operation.
Always adjust the speed and driving style to the current visibility, weath-
■
er, road and traffic conditions.
162
Driving
195.
during the regulation this is cancelled
Operation
Fig. 196 MAXI DOT display (monochrome): Examples of Speed Limiter sta-
tus displays
Fig. 197 Segment display: Examples of Speed Limiter status displays
162

Read and observe
163
Status display of the Speed
Speed limit is set, control is inactive (in the colour display the digits of

speed limits is shown in grey).
Control active (in the colour display the digits of the speed limits are high-

lighted).
No speed limit set.

System fault - seek assistance from a specialist garage immediately.

Basic requirements for start of control
The Speed Limiter is activated.

The current speed is higher than approx. 30 km/h.

on page 162 first.
Limiter» Fig. 196, » Fig. 197