Net Partition - Skoda Superb B8 Owner's Manual

›
Fold up the variable loading floor by moving it in the direction of the arrow
.
2
Dividing the luggage compartment
The luggage compartment can be divided with the variable loading floor in the
lower and upper position.
›
Raise the rear of the variable loading floor by the handle
›
Push the rear edge of the variable loading floor into the grooves
direction of the arrow.
The variable loading floor is secured against movements in the grooves

Net partition


Introduction
This chapter contains information on the following subjects:
Using the net partition
Removing and refitting the net partition housing
The net partition can either be extracted from behind the rear seats or behind
the front seats.
This chapter describes the procedure for extracting and rolling up the net par-
tition behind the rear seats.
Installing and removing the net partition from behind the front seats is carried
out in a similar way as behind the rear seats. Before pulling out the net parti-
tion, the rear seats are to be folded forwards. After rolling the net partition,
the rear seats are to be folded back
118
Using the system
Fig. 146
Dividing the boot with variable
loading floor
» Fig. 146.
A
B
» page 87.
Using the net partition
Fig. 147 Open part of the roll-up luggage compartment cover / release
lever
in the
.
B
118
Fig. 148 Correctly secure net partition behind the front seats in the
119
pulled-out state
Removing the net partition behind the rear seats
›
Fold out part of the roll-up luggage compartment cover
the arrow » Fig. 147.
›
Pull out the net partition at the upper crossbar
» Fig. 148.
›
Insert the transverse rod into one of the mounts
›
Insert the transverse rod into the mount
in the same way.
›
Make sure that the crossbar is firmly seated in the fittings
in the direction of
A
from the housing
C D
and push forwards.
E
on the other side of the vehicle
E
.
E
