Puncture Repair Kit - Skoda Superb B8 Owner's Manual

Follow-up tasks
After changing the wheel, the following work must be carried out.
›
Stow the replaced wheel in the wheel well and secure it with a special screw.
›
Stow the tool kit in the space provided and secure using the band.
›
Check the tyre pressure on the installed wheel as soon as possible.
›
Have the tightening torque of the wheel bolts checked with a torque wrench
as soon as possible.
After changing the wheel, the tyre pressure should be adjusted. In vehicles
with tyre pressure monitoring, save tyre pressure
Replace the damaged wheel or consult a specialist garage about repair op-
tions.
The prescribed tightening torque of the wheel bolts is 140 Nm.
WARNING
If the wheel bolts are tightened to a too low tightening torque, the rim
■
can come loose when the car is moving. A tightening torque which is too
high can damage the bolts and threads and this can result in permanent
deformation of the contact surfaces on the rim.
Drive cautiously and only at a moderate speed until the tightening torque
■
has been checked.

Puncture repair kit


Introduction
This chapter contains information on the following subjects:
Components of the puncture repair kits
General information
Preparations for using the breakdown kit
Sealing and inflating the tyre
Notes for driving with repaired tyres
Use the breakdown kit to reliably repair tyre damage caused by foreign bodies
or a puncture with diameters up to approx. 4 mm.
Performing a repair with the breakdown kit not at all intended to replace a
permanent repair on the tyre. Its purpose is to get you to the nearest specialist
garage.
228
Do-it-yourself
values» page 184.
228
229
229
229
230
The wheel must not be removed during repair.
Do not remove foreign bodies, which have penetrated the wheel profile from
the tyre (e.g. screws or nails).
Immediately replace the tyre that was repaired using the breakdown kit, or
consult a specialist garage about repair options.
WARNING
The sealant is hazardous to heath. Remove immediately if it comes into
■
contact with the skin.
Observe the manufacturer's usage instructions for the breakdown kit.
■
For the sake of the environment
Used sealant or sealant whose expiry date has passed must be disposed of in
accordance with environmental protection regulations.
Note
A new bottle of sealant can be purchased from ŠKODA Original Parts.
Components of the puncture repair kits
Fig. 247 Principle sketch: Components of the breakdown kit

Read and observe on page 228 first.
Components of the kit » Fig. 247
Sticker with speed designation "max. 80 km/h"/"max. 50 mph"
1
Valve remover
2 