Configuring The Function Performed By Controllers - Casio MZ-X500 User Manual

Configuring the Function Performed by Controllers

A variety of different functions can be assigned to the bq K1, K2 knobs, the MODULATION wheel, Pedal1, and
Pedal2.
1.
On the MENU screen, touch "CONTROLLER".
This displays the CONTROLLER screen.
2.
Touch "Enter" for the controller whose setting you want to configure.
This displays the Edit screen of the selected controller.
3.
In the "Parameter" column, touch "1" or "2".
• You can assign two functions to a single controller.
4.
Touch "Target".
This displays the Target screen.
5.
Touch the function you want to assign to the selected controller.
Setting
No Assign
CC00 to CC97
NRPN, RPN
Ch.Pressure
Tempo
EQ Low Gain - EQ High Gain
Upper 1 On/Off to Lower 2 On/Off
Upper 1 Volume to Metronome Volume
Layer Detune
Layer 1 to Layer 6
DSP 1 Bypass, DSP 2 Bypass
DSP 1 Param, DSP 2 Param
SysFX Bypass
MasFX Bypass
<Pedal only>
Rhythm S/S
<Pedal only>
Pad 1 to Pad 16 (MZ-X500)
Pad 1 to Pad 4 (MZ-X300)
* For details about each setting, see the MIDI Implementation Chart at the back of this manual and/or MIDI
documentation at http://world.casio.com/.
No function assigned.
MIDI control change*
MIDI NRPN and RPN parameters*
After selecting these parameters, adjust the settings below.
MSB: CC99 for NRPN, CC101 for RPN (Setting range: 000 to 127)
LSB: CC98 for NRPN, CC100 for RPN (Setting range: 000 to 127)
Data Entry MSB/LSB: Specifies which Data Entry (MSB (CC06) or LSB (CC38)) is
controlled by a controller operation. (Settings: MSB, LSB)
MIDI channel pressure*
Tempo setting
Master EQ > Low Gain - High Gain
Part On/Off
Balance adjustment of keyboard, Auto Accompaniment, and other volume levels
Layer detune
Tone parameter settings of each layer
• The following can be assigned: On/Off, Volume (Volume), Pan (panning),
OctShift (octave shift), DspOnOff (DSP1, 2 On/Off), LfoPitch (LFO pitch),
LfoFiltr (LFO filter), LfoAmp (LFO amp). For details about each setting, see
the editable parameter list under "Editing a Tone (User Tones)" (page EN-5).
Temporarily bypasses the DSP.
DSP Parameters
Temporarily bypasses system effects.
Temporarily bypasses master effects.
Starts/stops Auto Accompaniment.
Plays the assigned pad.
Configuring Settings (Tutorial)
Description
EN-83