Configuring Settings (Tutorial; Configuring Digital Keyboard Advanced Settings - Casio MZ-X500 User Manual

Configuring Settings (Tutorial)

Configuring Digital Keyboard Advanced Settings

This section explains general Digital Keyboard advanced settings. For information about other settings, see the
Digital Keyboard's USER'S GUIDE (Basics).
1.
On the MENU screen, touch "SYSTEM SETTING".
2.
Use the " " button on the right side of the screen to display page 3/3.
3.
Touch "Advanced".
4.
Advanced settings are described below.
Item
Use the ep OCTAVE w, q buttons to select the part whose octave you want
Octave Button Target
to change.
Use the eq SUSTAIN button to select the layer you want to change.
Sustain Button Target
Sustain Button Upper1 Specifies how the sustain effect is applied to Upper 1 when the eq SUSTAIN
button is pressed.
Sustain Button Upper2 Specifies how the sustain effect is applied to Upper 2 when the eq SUSTAIN
button is pressed.
Sustain Button Lower1 Specifies how the sustain effect is applied to Lower 1 when the eq SUSTAIN
button is pressed.
Sustain Button Lower2 Specifies how the sustain effect is applied to Lower 2 when the eq SUSTAIN
button is pressed.
N. Gate Thresh Specifies the noise gate threshold value. Cuts low-volume input sounds, which
decreases noise. Allows a signal input from the LINE IN terminal to pass
through if it is above the set threshold (gate open). Does not allow a signal to
pass if it is below the threshold (gate closed).
Init By Wave Parameter initialization by wave selection. Select "On" to link the envelope and
(MZ-X500 only) other parameters when a wave is selected or select "Off" not to link.
Exp. Pedal Calibration Performs an expression pedal calibration operation. Before performing this
operation, select "Exp. Pedal" (expression pedal) for the "Pedal 2 Type" setting
on the CONTROLLER screen.
1. When the message "Move the expression pedal to the highest position and
2. When the message "Move the expression pedal to the lowest position and
• Touch bo EXIT to exit the calibration operation.
Menu Setting Changes the arrangement of the icons on the MENU screen. On the Menu
Setting screen, use the "e" and "r" buttons to move each item upwards or
downwards. This will change the order of the icons on the MENU screen.
EN-80
Press "OK"" appears, keep the pedal depressed as your touch "OK".
Press "OK"" appears, keep the pedal released (pedal open) as you touch
"OK". The message "Complete!" will appear on the display when the
operation is complete.
Description Setting
Upper All, Upper 1,
Upper 2, Lower All,
Lower 1, Lower 2
Upper All, Upper 1,
Upper 2, Lower All,
Lower 1, Lower 2
0 to 127
0 to 127
0 to 127
0 to 127
0 to 127
Off, On