Sequentially Recalling Registered Setups (Registration Sequence; Specifying The Recall Sequence - Casio MZ-X500 User Manual

Sequentially Recalling Registered Setups
(Registration Sequence)
You can configure the Digital Keyboard so its setup
changes in a preset sequence each time a specified
pedal is pressed. Setups are those registered in areas
within a single particular registration bank.
• For information about how to configure registration
function setups, see the Digital Keyboard's USER'S
GUIDE (Basics).
• For details about settings, see the "Parameter List"
in the separate Appendix.
Specifying the Recall
Sequence
Use the procedure in this section to specify sequence in
which areas are recalled (registration sequence) when
the pedal is pressed. You can have up to 12 sequences
configured.
1.
On the MENU screen, touch
"REGISTRATION".
2.
Touch "Sequence Edit".
This displays the REGISTRATION SEQUENCE EDIT
screen.
3.
Touch the "Sequence Data No." number and
then use the 9 w/NO, q/YES buttons to
specify the number of the sequence you want
to edit.
4.
Touch the "Bank" number and then use the
9 w/NO, q/YES buttons to specify the
bank where the setups you want to use in the
sequence are located.
5.
Touch sequence step 01 and then use the 9
w/NO, q/YES buttons to specify the
number of the area that includes the first
setup you want to recall.
Sequence
EN-46
6.
Repeat step 5 as required to specify areas for
the other steps of the sequence.
• Select "End" to specify the final step of the sequence.
7.
Touch the Sequence End Type name.
8.
On the SEQUENCE END SELECT screen
that appears, select the operation to be
performed when the sequence reaches
"End".
None: Does nothing.
Repeat:
Returns to Step 01 of the currently selected sequence.
Next Seq Data:
Jumps to Step 01 of the next sequence.
Sequence Data 1 to 12:
Jumps to Step 01 of the specified sequence.
9.
Touch "Pedal 1 Type" or "Pedal 2 Type" to
specify pedal operation.
Increment:
Advances to the next sequence step. Pressing the pedal
while the current sequence step is "Top*" will jump to
Step 1 of the sequence. Pressing the pedal when the
destination of the operation is "End", will perform an
operation in accordance with the "Sequence End Type"
setting. Configuring this setting disables the pedal
setting configured on the CONTROLLER screen.
Decrement:
Returns to the previous sequence step. Decrement
cannot be performed while the current sequence step is
"Top*" or Step 01. Configuring this setting disables the
pedal setting configured on the CONTROLLER screen.
Off:
Disables changing of the sequence step by the pedal.
Selecting "Off" for this setting enables the pedal setting
configured on the CONTROLLER screen.
* Top indicates the beginning of sequence data.
Increment recalls Step 01. Moving to Top from
another sequence position does not recall
anything.