Sony MVC-FD100 Service Manual page 46

MVC-FD100/FD100H/FD200/FD200H
[Notes when attaching the top cover]
1. Be careful not touch the grease that is coated at the 8 locations as shown below.
2. When attaching the top cover to a drive, be careful that the FPC of S1 must not be caught into the drive. Observe that the FPC of
S1 must not be caught into the drive, by observing the position of FPC through the hole of the top cover as shown below. Also be
careful that the 6-pin FPC must not be caught into a drive at the same time.
This line of the top cover is a guideline.
The 6-pin FPC must not be caught into a drive
3. Be sure not to forget to engage an end of the shutter spring in this hole.
The hole in which an end of the shutter spring is engaged.
4. When tightening the screws, there is an order tightening the screws. Follow the order as shown below.
(Tightening torque: 9.8N•cm(1.0kg•cm)±10%)
8 locations
NG OK
OK
1 2 3 4
2-14