Cab-1 Remote Controller Numeric Keypad Commands - Lionel legacy super bass AC6000 Owner's Manual

TrainMaster Command Control operations

CAB-1 Remote Controller numeric keypad commands

W
hen you press the AUX1 button on your CAB-1 Remote
Controller, you turn the numeric keypad into ten command
buttons. These commands are specific to your locomotive, and an
overlay is included to help you learn these functions. After you press
the AUX1 button, you will be able to press any numbered button until
you address a different Command Control equipped product. The
corresponding LEGACY RailSounds sound system effects
are in bold italic type.
Stops and resets the locomotive. Resets the locomotive's direction to
forward. Horn blows. RPM sounds return to automatic.
Raises the volume of the LEGACY RailSounds sound system background sounds, such as RPM
sounds and let-off sounds. The horn, bell and dialog are unaffected. The default is full volume.
The volume setting is retained when track power is turned off. Sound volume increases.
Engineer begins radio dialog, dispatcher replies (see page 27). CrewTalk
communication.
Enters manual RPM mode and increases the RailSounds sound system RPM level (see
page 14). If the LEGACY RailSounds sound system is shut down (see 5 key below), AUX1, 3
activates a full LEGACY RailSounds sound system start-up while the locomotive is stopped after
pressing AUX1, 5 with track power on.
Lowers the volume of the LEGACY RailSounds sound system background sounds, such as RPM
sounds and let-off sounds. The horn, bell, and dialog are unaffected. The volume setting is
retained when track power is turned off. Sound volume decreases.
Activates the LEGACY RailSounds sound system shutdown sequence when stopped. Note that in
the shutdown sequence, the smoke unit does not turn off if it was already on. To turn off the
smoke unit, press AUX1, 8 or use the smoke unit SMK/NO SMK switch.
Enters manual RPM mode and lowers the LEGACY RailSounds diesel motor RPM level (see
page 14).
Dispatcher begins radio dialog, engineer replies (see page 27). TowerCom
announcement.
Turns off the smoke unit. Air release sound.
Turns on the smoke unit if the smoke unit switch is in the SMK position. Be sure to add smoke
fluid before turning on the smoke unit to prevent damage to your locomotive. Steam
generator blow-off sound.
AUX1, 8 and 9 function only if the locomotive's smoke unit switch is in the SMK
Note!
position. Sounds will be active in both switch positions.
72-8305-250_NP_AC6000_2.indd 12
12
2/27/09 10:15 AM