Adjusting The Smoke Output; Replacing Your Non-Powered Locomotive's Leds And Lamps - Lionel legacy super bass AC6000 Owner's Manual

Maintaining and servicing your locomotive

Adjusting the smoke output

Y
our non-powered locomotive features an improved smoke unit with variable smoke output. In
the TrainMaster Command Control environment, you may select low, medium, or high smoke
output using your CAB-1 Remote Controller. Your locomotive is shipped from the factory in the
medium smoke output setting.
To adjust the smoke output, bring the non-powered locomotive to a stop, press AUX1, AUX2,
9, then press L for low smoke, M for medium smoke, or H for high smoke. Press AUX2 again to
complete the setting. See page 11 for the location of these buttons on the CAB-1 Remote Controller.
Your non-powered locomotive will remember its new setting until you change it again.
It may take up to a minute for the smoke unit to heat up or cool down to the new setting.
Note!
In the conventional environment, smoke output is always at the medium level. Smoke
Note!
output is not variable in the conventional environment.

Replacing your non-powered locomotive's LEDs and lamps

Y
our non-powered locomotive is illuminated by several LEDs and lamps. During the course of
normal operations, they may require replacement.
We recommend that you have the LED and lamp replacemenst done at an authorized Lionel
Service Center. See the Lionel Service section on page 32 for more information.
72-8305-250_NP_AC6000_2.indd 30
30
2/27/09 10:15 AM