Reprogramming Your Non-Powered Locomotive To Restore Features - Lionel legacy super bass AC6000 Owner's Manual

TrainMaster Command Control operations

Reprogramming your non-powered locomotive to restore features

I
f your non-powered locomotive is unresponsive to your commands in the TrainMaster
Command Control environment, we recommend that you follow this procedure to reset your
locomotive.
1. Slide the Command reverse unit switch to the PGM position.
2. Plug in and connect your Command Base.
3. Place your non-powered locomotive on the track, then power up the track.
4. Press ENG and enter the locomotive's ID#.
5. Press SET.
6. Press ENG and enter the locomotive's ID# again.
7. Press AUX1.
8. Enter 2 for this particular locomotive.
9. Turn off track power and wait ten seconds.
10. Slide the Command reverse unit switch back to the RUN position.
At this point, your non-powered locomotive has been reset. Restore power to the track and
operate the locomotive as usual. Be sure to use the ID# entered in Step 4.
72-8305-250_NP_AC6000_2.indd 17
17
2/27/09 10:15 AM