Operating Your Non-Powered Locomotive In The Command Control Environment - Lionel legacy super bass AC6000 Owner's Manual

TrainMaster Command Control operations
Operating your non-powered locomotive in the Command Control
environment
Couple your non-powered locomotive to a powered locomotive for operation in the
Note!
Command Control environment.
1. Turn off track power and plug-in the Command Base. Be sure that the Command Base
is connected to the outside rail or to the Common/Ground/U terminal on your track power supply.
2. Place your non-powered locomotive on Lionel or Lionel-compatible O-36
or larger track.
3. Increase track voltage to full power (no more than 19 volts AC). On PowerMasters,
slide the CMD/CONV switch to CMD. Program Track Power Controllers to Command Control
operation.
Power your non-powered locomotive with an alternating-current (AC) transformer
Caution!
only. Powering your locomotive with a direct-current (DC) transformer, or in excess of
19 volts AC, may result in damage to sensitive electronic components.
4. Press ENG and enter the ID# to address your locomotive with your CAB-1
Remote Controller. All Lionel locomotives come factory-programmed as ID# 1. To change the
ID#, see page 15.
5. Throttle up and move 'em out! Your non-powered locomotive will respond to every
command from your CAB-1 Remote Controller.
72-8305-250_NP_AC6000_2.indd 10
10
2/27/09 10:15 AM