Legacy Control Systems Operations; Get Ready To Run; Start 'Er Up - Lionel legacy super bass AC6000 Owner's Manual

LEGACY Control System operations
Please note that not all LEGACY products have all the features
mentioned in this section.
This section is a brief overview of the LEGACY Control System. For a more in depth
Note!
explanation of the LEGACY Control System features, please see your LEGACY Control
System Operations Manual.

GET READY TO RUN

Couple your non-powered locomotive to a powered locomotive for operation in the
Note!
LEGACY Control System environment.
G
et your engine running now by following the instructions in this guide. We'll power up the track,
"address the engine" so it can be controlled by your CAB-2 remote and learn to use the Whistle
and Bell commands.
Power Up The Track
Refer to PowerMaster, TPC, or ZW manual for correct method. With your engine on the track and
ready to roll, power-up your track to a constant 18 volts. If a circuit breaker trips when you turn on
the Lionel power supply, check the wheels of your locomotive to make sure they are all securely on
the track. Check to make sure the track is free of all metals that may cause a short circuit.
Address Your Engine
First, you must address the engine. This "tells" your CAB-2 which locomotive you want to control.
This is important when you have more than one engine on your layout.
To address an engine:
1. Press ENG
2. Press 1
3. Press Start Up
See reference numbers 1, 2, and 3

Start 'Er Up

Now it is time to start up your engine's sound system.
To start the engine's Railsounds system, press Start on the touch-screen or any action key
(Whistle, Bell, Velocity Throttle, etc.).
Your engine sound system will start up and the Touch-screen Control Panel will appear.
72-8305-250_NP_AC6000_2.indd 4
4
2/27/09 10:15 AM