Repeater Support; Protecting Against Unauthorised Access; Restoring The Base To The Factory Settings - Siemens GIGASET C595 Manual

•

Repeater support

With a repeater you can increase the range
and signal strength of your base. You will
need to activate repeater mode. This will
terminate any calls that are in progress at
the time.
Precondition: A repeater is registered.
Ï
¢ ¢
v
System
Press to deactivate repeater mode
§Change§
(³= on).
Please note
Eco Mode / Eco Mode+ (
and repeater support cancel each
other out, i.e. if you use a repeater you
cannot use Eco Mode and Eco Mode+.
•
Protecting against
unauthorised access
Protect the system settings of the base
with a PIN known only to yourself. The sys-
tem PIN must be entered when, for exam-
ple, registering/deregistering a handset
to/from the base or when restoring the
default settings.
Changing the system PIN
You can change the 4-digit system PIN set
on the base (default setting: 0000) to a 4-
digit PIN known only by you.
Gigaset C595: Setting a system PIN facili-
tates remote operation of the answering
¢
machine page 53.
Ï
¢ ¢
v
System
~
Enter the current system PIN
and press
~
Enter your new system PIN
and press
¢
Repeater Mode
¢
page 55)
¢
System PIN
.
§OK§
.
§OK§
Resetting the system PIN
If you have forgotten your system PIN you
can reset the base to the original code
0000:
Disconnect the power cord from the base.
Hold down the registration/paging key on
the base while reconnecting the power
cable to the base. Press and hold the key
for at least five seconds.
The base has now been reset and the sys-
tem PIN 0000 set.
Please note
All handsets are deregistered and must
be re-registered. All settings are
restored to the factory settings.
•
Restoring the base to the
factory settings
When the settings are restored
u
date and time will be retained
u
handsets are still registered
u
Eco Mode is switched on and
Eco Mode+ is switched off
u
the system PIN is not reset
Ï
¢ ¢
v
System
~
Enter the system PIN and
press
§OK§
Press the display key.
§Yes§
Base settings
¢
Base Reset
.
67