Repeater Support; Resetting The Base To The Default Settings; Reset Handset; Repeater Mode - Siemens Gigaset C590 IP User Manual

•

Repeater support

You can increase the range and signal strength of your phone using a repeater. To
do this you need to activate repeater mode. This will terminate any calls that are in
progress at the time.
Prerequisite: Eco mode(+) is deactivated.
¢
Ï
v
§Change§
§Yes§
Please note
u
Repeater support and Eco Mode / Eco Mode+
other out, i.e., both functions cannot be used at the same time.
u
The default encrypted transmission setting is deactivated when repeater
mode is activated.

Resetting the base to the default settings

The individual settings are reset.
Resetting the base via the menu
When the settings are restored:
u
Handsets are still registered
u
The system PIN is not reset.
The following settings in particular are reset to the default settings (you can make
the settings marked "*" via the Web configurator):
u
The entered VoIP connections (are deleted)
u
The assignment of send and receive connections
u
Audio settings for VoIP connections *
u
DTMF settings *
u
Own area code
u
Settings for the local network
u
The names of the handsets
u
SMS settings (e.g., SMS service centres)
u
Eco Mode and Eco Mode+ are deactivated.
u
PABX connection settings
Digit and display key assignments as well as the key
u
u
Settings for network services: call divert
¢ ¢
System

Repeater Mode

Press the display key to activate or deactivate repeater mode (³= on).
Press the display key to confirm the prompt.
Configuring the system settings
¢
( page 121) cancel each
153