Nose Gear Installation; Installing The Nose Gear Wheel; Mounting The Engine - Seagull Models JUMPER 25 Instruction Manual

JUMPER 25.

NOSE GEAR INSTALLATION.

Installing steering arm as follow.
Steering arm.
Connector.
Adjust the nose gear steering arm until the
arm is parallel with the fire wall.
Pushrod wire.
8
Steering arm.
Instruction Manual.

INSTALLING THE NOSE GEAR WHEEL.

Slide one wheel onto the axle and push
them up against the wheel collars. Slide the
remaining wheel collars with set screws onto
the axles. Push them up against the wheels
and tighten the set screws. The wheels should
spin free and

MOUNTING THE ENGINE.

1) Install the pushrod housing through the
predrilled hole in the firewall and into the servo
compartment. The pushrod housing should
protrude 1/4" out past the front of the firewall.
Make a Z-Bend 1/4" from one end of the plain
wire pushrod.
11cm.
2) Place your engine onto the engine
mount. Adjust the engine is centered of the
edges of the engine case.
3) When you are satisfied with the align-
ment, mark the locations of the engine
mounting.
4) Remove the engine. Using an drill bit,
drill the mounting holes through the engine
mount at the four locations marked.