Part
Heater
Reassembly is in the reverse order of the removal.
Photo
3. Disassembly and Reassembly
Description
Preparation:
*
Make sure to disconnect the power.
*
Disassemble the cover sump & cutter disposer.
*
Disassemble the shutter & bracket front lower.
-
Refer the each disassembly section.
1. Remove the two (2) heater connectors.
2. Remove a ground screw on the heater bracket.
3. Release a nut using nutdriver(10mm).
4. Push the heater inside of case sump carefully.
Caution
The heater may be very hot. Make sure to check it
before touching the heater.
Caution
Make sure to check whether any water is left.
Remove any remaining water, to prevent water
leakages while servicing.
3-19