Part
Control Panel
+
Window Panel
(DMT800)
Control Panel
(DMT400)
Reassembly is in the reverse order of the removal.
Photo
3. Disassembly and Reassembly
Description
Preparation:
* Disassemble the frame front , Assy control panel
and Door lock switch.
- Refer the "Frame front" disassembly section to
separate the Frame front.
1. Remove the two(2) screws on the control panel
and release the window panel using flat screw
driver.
- Insert the flat screw driver into the gap of screw
boss and turn it over.
2. Rotate the window panel to upside and
disconnect the wire connector.
3. Release the two(2) screws on the window panel
to release the guide LED.
Preparation:
* Disassemble the frame front , Assy control panel
and Door lock switch.
- Refer the "Frame front" disassembly section to
separate the Frame front.
1. Remove two(2) connectors in the display – PCB.
2. Pull the control panel up slightly from Assy frame
front , and pull it out.
3. Unscrew two(2) screws to remove display-PCB
and guide-LED.
4. Disconnect the 2 wire connectors from control
panel(touch-PCB).
3-5