Shutter And Leakage Sensor; Rear Leg, Case Gear And Adjust Leg Bar - Samsung DMT800 SERIES Service Manual

3. Disassembly and Reassembly
Part
Shutter
&
Leakage Sensor
Rear Leg
&
Case gear
&
Adjust leg bar
Reassembly is in the reverse order of the removal.
3-14
Photo Description
Preparation:
* Make sure to disconnect the power & water supply
& drain hose connections.
* Remove the upper & lower baskets in the
dishwasher.
* Pull out the dishwasher carefully.
1. Lay down the dishwasher on its back. Release the
two(2) screws fixing the base and shutter in place.
2. Pull out the shutter and release the leakage sensor
connector.
3. Remove the leakage sensor from the shutter by
unfastening the two(2) screws.
Preparation:
* Make sure to disconnect the power & water supply
& drain hose connections.
* Remove the upper & lower baskets in the
dishwasher.
* Pull out the dishwasher & Lay down the dishwasher
on its back carefully.
* Remove the shutter.
1. Rotate the rear leg adjust bar below Door to right
turn entirely until pull out the rear leg.
2. Release the screw that is holding case gear and
remove it.
3. Case gear is made up of worm gear and helical
gear. Pull out worm gear at first.
4. Hold the adjust bar & pull in it pushing helical gear
from backside.
Adjust leg bar is holding by hook which is inside red
circle.