Filter Mesh Body, Cover Sump, Impeller, Case Scroll, Disposer - Samsung DMT800 SERIES Service Manual

Part
Filter Mesh body
&
Cover Sump
&
Impeller
&
Case scroll
&
Disposer
Reassembly is in the reverse order of the removal.
Photo
3. Disassembly and Reassembly
Description
Preparation:
* Disassemble the baskets, nozzles and storm wash
nozzle.
- Refer the each disassembly section to separate.
1. Release the 13 screws on Assy sump. (Except the
two (2) screws holding the holder nozzle L in center
place.) Take off the filter mesh body, cover sump(&
holder nozzle L).
2. Pull out the Assy cover sump slightly. And, Hold and
rotate slightly the duct nozzle & Assy case sump
each other.
3. Release the screw (1) that is fixing the impeller and
circulation motor shaft.
Caution : Use the gloves for your hand to hold the
impeller during releasing the screw. Be careful your
hands to harm.
(Only for DMT800 & DMT700 series)
4. Remove the plate-distribute.
5. Remove the case scroll. Check if the seal rubber
scroll is normal. If it is damaged or hardened,
replace it.
6. Remove the cutter disposer.
Caution
Both sides of cutter are sharp. Be careful when
removing it. "U" stamp is upside.
Place the removed parts in a safe location to prevent
them from being damaged.
3-11