Drain Pump; Turbidity Sensor - Samsung DMT800 SERIES Service Manual

Part

Drain Pump

Turbidity Sensor

Reassembly is in the reverse order of the removal.
Photo
3. Disassembly and Reassembly
Description
Preparation:
* Disassemble the shutter.
- Refer the "shutter" disassembly section.
1. Remove the drain pump by rotating it clockwise
lifting up the hook holding it in place slightly.
Caution
Make sure to remove remain water in the
dishwasher. If not, wet the floor.
The drain pump has a seal .
2. Disconnect the two(2) drain pump connectors.
Preparation:
* Disassemble the shutter.
- Refer the "shutter" disassembly section.
1. Remove the turbidity sensor connector.
2. Remove the two hooks from the turbidity sensor.
Caution
Use a flat screwdriver carefully to remove it from the
Assy sump preventing breakage.
The turbidity sensor has a seal.
3-17